From 07194ab7be63a972096309ab0ea747df455c6a20 Mon Sep 17 00:00:00 2001 From: Luben Tuikov Date: Fri, 11 Feb 2011 11:33:10 -0800 Subject: USB: Reset USB 3.0 devices on (re)discovery If the device isn't reset, the XHCI HCD sends SET ADDRESS to address 0 while the device is already in Addressed state, and the request is dropped on the floor as it is addressed to the default address. This sequence of events, which this patch fixes looks like this: usb_reset_and_verify_device() hub_port_init() hub_set_address() SET_ADDRESS to 0 with 1 usb_get_device_descriptor(udev, 8) usb_get_device_descriptor(udev, 18) descriptors_changed() --> goto re_enumerate: hub_port_logical_disconnect() kick_khubd() And then: hub_events() hub_port_connect_change() usb_disconnect() usb_disable_device() new device struct sets device state to Powered choose_address() hub_port_init() <-- no reset, but SET ADDRESS to 0 with 1, timeout! The solution is to always reset the device in hub_port_init() to put it in a known state. Note from Sarah Sharp: This patch should be queued for stable trees all the way back to 2.6.34, since that was the first kernel that supported configured device reset. The code this patch touches has been there since 2.6.32, but the bug would never be hit before 2.6.34 because the xHCI driver would completely reject an attempt to reset a configured device under xHCI. Signed-off-by: Luben Tuikov Signed-off-by: Sarah Sharp Cc: stable@kernel.org --- drivers/usb/core/hub.c | 18 +++++++----------- 1 file changed, 7 insertions(+), 11 deletions(-) (limited to 'drivers/usb/core/hub.c') diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c index d041c6826e4..0f299b7aad6 100644 --- a/drivers/usb/core/hub.c +++ b/drivers/usb/core/hub.c @@ -2681,17 +2681,13 @@ hub_port_init (struct usb_hub *hub, struct usb_device *udev, int port1, mutex_lock(&usb_address0_mutex); - if (!udev->config && oldspeed == USB_SPEED_SUPER) { - /* Don't reset USB 3.0 devices during an initial setup */ - usb_set_device_state(udev, USB_STATE_DEFAULT); - } else { - /* Reset the device; full speed may morph to high speed */ - /* FIXME a USB 2.0 device may morph into SuperSpeed on reset. */ - retval = hub_port_reset(hub, port1, udev, delay); - if (retval < 0) /* error or disconnect */ - goto fail; - /* success, speed is known */ - } + /* Reset the device; full speed may morph to high speed */ + /* FIXME a USB 2.0 device may morph into SuperSpeed on reset. */ + retval = hub_port_reset(hub, port1, udev, delay); + if (retval < 0) /* error or disconnect */ + goto fail; + /* success, speed is known */ + retval = -ENODEV; if (oldspeed != USB_SPEED_UNKNOWN && oldspeed != udev->speed) { -- cgit v1.2.3