From fb1d9be5967fff0a3c93b06304fd992e3c438b7f Mon Sep 17 00:00:00 2001 From: Mike Frysinger Date: Sun, 29 May 2011 23:12:51 -0400 Subject: Blackfin: optimize double fault boot checking This moves the double fault data used at boot time into a single struct which can then easily be addressed with indexed loads rather than having to explicitly load multiple addresses. Signed-off-by: Mike Frysinger --- arch/blackfin/mach-common/head.S | 36 ++++++++++++------------------------ 1 file changed, 12 insertions(+), 24 deletions(-) (limited to 'arch/blackfin/mach-common/head.S') diff --git a/arch/blackfin/mach-common/head.S b/arch/blackfin/mach-common/head.S index 76de5724c1e..8b4d9885440 100644 --- a/arch/blackfin/mach-common/head.S +++ b/arch/blackfin/mach-common/head.S @@ -85,37 +85,25 @@ ENTRY(__start) SSYNC; /* in case of double faults, save a few things */ - p0.l = _init_retx; - p0.h = _init_retx; - R0 = RETX; - [P0] = R0; - + p1.l = _initial_pda; + p1.h = _initial_pda; + r4 = RETX; #ifdef CONFIG_DEBUG_DOUBLEFAULT /* Only save these if we are storing them, * This happens here, since L1 gets clobbered * below */ GET_PDA(p0, r0); - r5 = [p0 + PDA_DF_RETX]; - p1.l = _init_saved_retx; - p1.h = _init_saved_retx; - [p1] = r5; - - r5 = [p0 + PDA_DF_DCPLB]; - p1.l = _init_saved_dcplb_fault_addr; - p1.h = _init_saved_dcplb_fault_addr; - [p1] = r5; - - r5 = [p0 + PDA_DF_ICPLB]; - p1.l = _init_saved_icplb_fault_addr; - p1.h = _init_saved_icplb_fault_addr; - [p1] = r5; - - r5 = [p0 + PDA_DF_SEQSTAT]; - p1.l = _init_saved_seqstat; - p1.h = _init_saved_seqstat; - [p1] = r5; + r0 = [p0 + PDA_DF_RETX]; + r1 = [p0 + PDA_DF_DCPLB]; + r2 = [p0 + PDA_DF_ICPLB]; + r3 = [p0 + PDA_DF_SEQSTAT]; + [p1 + PDA_INIT_DF_RETX] = r0; + [p1 + PDA_INIT_DF_DCPLB] = r1; + [p1 + PDA_INIT_DF_ICPLB] = r2; + [p1 + PDA_INIT_DF_SEQSTAT] = r3; #endif + [p1 + PDA_INIT_RETX] = r4; /* Initialize stack pointer */ sp.l = _init_thread_union + THREAD_SIZE; -- cgit v1.2.3