aboutsummaryrefslogtreecommitdiffstats
path: root/drivers/staging/comedi/drivers/rtd520.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/staging/comedi/drivers/rtd520.c')
-rw-r--r--drivers/staging/comedi/drivers/rtd520.c12
1 files changed, 6 insertions, 6 deletions
diff --git a/drivers/staging/comedi/drivers/rtd520.c b/drivers/staging/comedi/drivers/rtd520.c
index 357858d2744..7f09ed755fe 100644
--- a/drivers/staging/comedi/drivers/rtd520.c
+++ b/drivers/staging/comedi/drivers/rtd520.c
@@ -75,7 +75,7 @@ Configuration options:
das1800, since they have the best documented code. Driver
cb_pcidas64.c uses the same DMA controller.
- As far as I can tell, the About interrupt doesnt work if Sample is
+ As far as I can tell, the About interrupt doesn't work if Sample is
also enabled. It turns out that About really isn't needed, since
we always count down samples read.
@@ -370,7 +370,7 @@ struct rtdPrivate {
/* timer gate (when enabled) */
u8 utcGate[4]; /* 1 extra allows simple range check */
- /* shadow registers affect other registers, but cant be read back */
+ /* shadow registers affect other registers, but can't be read back */
/* The macros below update these on writes */
u16 intMask; /* interrupt mask */
u16 intClearMask; /* interrupt clear mask */
@@ -485,7 +485,7 @@ struct rtdPrivate {
#define RtdAdcFifoGet(dev) \
readw(devpriv->las1+LAS1_ADC_FIFO)
-/* Read two ADC data values (DOESNT WORK) */
+/* Read two ADC data values (DOESN'T WORK) */
#define RtdAdcFifoGet2(dev) \
readl(devpriv->las1+LAS1_ADC_FIFO)
@@ -857,7 +857,7 @@ static int rtd_attach(struct comedi_device *dev, struct comedi_devconfig *it)
DPRINTK("rtd520: PCI latency = %d\n", pci_latency);
}
- /* Undocumented EPLD version (doesnt match RTD driver results) */
+ /* Undocumented EPLD version (doesn't match RTD driver results) */
/*DPRINTK ("rtd520: Reading epld from %p\n",
devpriv->las0+0);
epld_version = readl (devpriv->las0+0);
@@ -1291,7 +1291,7 @@ static int rtd520_probe_fifo_depth(struct comedi_device *dev)
/*
"instructions" read/write data in "one-shot" or "software-triggered"
mode (simplest case).
- This doesnt use interrupts.
+ This doesn't use interrupts.
Note, we don't do any settling delays. Use a instruction list to
select, delay, then read.
@@ -2120,7 +2120,7 @@ static int rtd_ai_cmd(struct comedi_device *dev, struct comedi_subdevice *s)
}
/*
- Stop a running data aquisition.
+ Stop a running data acquisition.
*/
static int rtd_ai_cancel(struct comedi_device *dev, struct comedi_subdevice *s)
{