aboutsummaryrefslogtreecommitdiffstats
path: root/arch/arm/boot/dts/phy3250.dts
diff options
context:
space:
mode:
Diffstat (limited to 'arch/arm/boot/dts/phy3250.dts')
-rw-r--r--arch/arm/boot/dts/phy3250.dts71
1 files changed, 64 insertions, 7 deletions
diff --git a/arch/arm/boot/dts/phy3250.dts b/arch/arm/boot/dts/phy3250.dts
index c4ff6d1a018..90fdbd77f27 100644
--- a/arch/arm/boot/dts/phy3250.dts
+++ b/arch/arm/boot/dts/phy3250.dts
@@ -54,6 +54,17 @@
#address-cells = <1>;
#size-cells = <1>;
+ nxp,wdr-clks = <14>;
+ nxp,wwidth = <40000000>;
+ nxp,whold = <100000000>;
+ nxp,wsetup = <100000000>;
+ nxp,rdr-clks = <14>;
+ nxp,rwidth = <40000000>;
+ nxp,rhold = <66666666>;
+ nxp,rsetup = <100000000>;
+ nand-on-flash-bbt;
+ gpios = <&gpio 5 19 1>; /* GPO_P3 19, active low */
+
mtd0@00000000 {
label = "phy3250-boot";
reg = <0x00000000 0x00064000>;
@@ -83,6 +94,14 @@
};
apb {
+ uart5: serial@40090000 {
+ status = "okay";
+ };
+
+ uart3: serial@40080000 {
+ status = "okay";
+ };
+
i2c1: i2c@400A0000 {
clock-frequency = <100000>;
@@ -114,32 +133,70 @@
};
ssp0: ssp@20084000 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ num-cs = <1>;
+ cs-gpios = <&gpio 3 5 0>;
+
eeprom: at25@0 {
+ pl022,interface = <0>;
+ pl022,com-mode = <0>;
+ pl022,rx-level-trig = <1>;
+ pl022,tx-level-trig = <1>;
+ pl022,ctrl-len = <11>;
+ pl022,wait-state = <0>;
+ pl022,duplex = <0>;
+
+ at25,byte-len = <0x8000>;
+ at25,addr-mode = <2>;
+ at25,page-size = <64>;
+
compatible = "atmel,at25";
+ reg = <0>;
+ spi-max-frequency = <5000000>;
};
};
+
+ sd@20098000 {
+ wp-gpios = <&gpio 3 0 0>;
+ cd-gpios = <&gpio 3 1 0>;
+ cd-inverted;
+ bus-width = <4>;
+ status = "okay";
+ };
};
fab {
+ uart2: serial@40018000 {
+ status = "okay";
+ };
+
tsc@40048000 {
status = "okay";
};
+
+ key@40050000 {
+ status = "okay";
+ keypad,num-rows = <1>;
+ keypad,num-columns = <1>;
+ nxp,debounce-delay-ms = <3>;
+ nxp,scan-delay-ms = <34>;
+ linux,keymap = <0x00000002>;
+ };
};
};
leds {
compatible = "gpio-leds";
- led0 {
- gpios = <&gpio 5 1 1>; /* GPO_P3 1, GPIO 80, active low */
- linux,default-trigger = "heartbeat";
+ led0 { /* red */
+ gpios = <&gpio 5 1 0>; /* GPO_P3 1, GPIO 80, active high */
default-state = "off";
};
- led1 {
- gpios = <&gpio 5 14 1>; /* GPO_P3 14, GPIO 93, active low */
- linux,default-trigger = "timer";
- default-state = "off";
+ led1 { /* green */
+ gpios = <&gpio 5 14 0>; /* GPO_P3 14, GPIO 93, active high */
+ linux,default-trigger = "heartbeat";
};
};
};