Diffstat (limited to 'Documentation/block/cfq-iosched.txt')
1 files changed, 77 insertions, 0 deletions
diff --git a/Documentation/block/cfq-iosched.txt b/Documentation/block/cfq-iosched.txt
index 6d670f57045..d89b4fe724d 100644
@@ -1,3 +1,14 @@
+CFQ (Complete Fairness Queueing)
+The main aim of CFQ scheduler is to provide a fair allocation of the disk
+I/O bandwidth for all the processes which requests an I/O operation.
+CFQ maintains the per process queue for the processes which request I/O
+operation(syncronous requests). In case of asynchronous requests, all the
+requests from all the processes are batched together according to their
+process's I/O priority.
CFQ ioscheduler tunables
@@ -25,6 +36,72 @@ there are multiple spindles behind single LUN (Host based hardware RAID
controller or for storage arrays), setting slice_idle=0 might end up in better
throughput and acceptable latencies.
+This specifies, given in Kbytes, the maximum "distance" for backward seeking.
+The distance is the amount of space from the current head location to the
+sectors that are backward in terms of distance.
+This parameter allows the scheduler to anticipate requests in the "backward"
+direction and consider them as being the "next" if they are within this
+distance from the current head location.
+This parameter is used to compute the cost of backward seeking. If the
+backward distance of request is just 1/back_seek_penalty from a "front"
+request, then the seeking cost of two requests is considered equivalent.
+So scheduler will not bias toward one or the other request (otherwise scheduler
+will bias toward front request). Default value of back_seek_penalty is 2.
+This parameter is used to set the timeout of asynchronous requests. Default
+value of this is 248ms.
+This parameter is used to set the timeout of synchronous requests. Default
+value of this is 124ms. In case to favor synchronous requests over asynchronous
+one, this value should be decreased relative to fifo_expire_async.
+This parameter is same as of slice_sync but for asynchronous queue. The
+default value is 40ms.
+This parameter is used to limit the dispatching of asynchronous request to
+device request queue in queue's slice time. The maximum number of request that
+are allowed to be dispatched also depends upon the io priority. Default value
+for this is 2.
+When a queue is selected for execution, the queues IO requests are only
+executed for a certain amount of time(time_slice) before switching to another
+queue. This parameter is used to calculate the time slice of synchronous
+time_slice is computed using the below equation:-
+time_slice = slice_sync + (slice_sync/5 * (4 - prio)). To increase the
+time_slice of synchronous queue, increase the value of slice_sync. Default
+value is 100ms.
+This specifies the number of request dispatched to the device queue. In a
+queue's time slice, a request will not be dispatched if the number of request
+in the device exceeds this parameter. This parameter is used for synchronous
+In case of storage with several disk, this setting can limit the parallel
+processing of request. Therefore, increasing the value can imporve the
+performace although this can cause the latency of some I/O to increase due
+to more number of requests.
CFQ IOPS Mode for group scheduling
Basic CFQ design is to provide priority based time slices. Higher priority